Elite Technical is seeking an electrical engineer with digital circuit card assembly design experience for a long-term position in Rochester, NY. Due to the nature of the work to be performed, any candidate seeking consideration for this position must be a U.S. citizen capable of obtaining and maintaining a DoD secret clearance.
- Digital CCA design including requirements generation, preliminary design, peer reviews, detailed design, test plan generation, and integration and test.
- Understand the requirements and architect a digital CCA solution against those requirements including the use of DSP, Microcontroller, FPGA, ASIC, CPLD, ADC, DAC, Point of Load (POL), SERDES, Serial (I2C, SPI, etc), and volatile/non-volatile memory (DDRx, SRAM, ROM, Flash, etc) components.
- Simulate the digital CCA circuits to verify performance, then integrate and test the CCA into the higher level assembly (Signal Integrity simulation).
- Lead a small team of designers in generating the digital CCA design solutions.
BSEE Degree with 6 years of experience in electrical engineering in the role of digital CCA design, or equivalent.
Experience with design for test and design for manufacturability techniques.
Experience with high reliability designs for harsh environments (radiation effects).
Experience with high speed memory interfaces (DDRx).
Experience with high speed serial protocols (PCI Express, SRIO, Ethernet).
Experience with Analog to Digital (AD) and Digital to Analog (DA) interfaces.
Experience with control protocols such I2C, SPI, RS-232/422, and SpaceWire.
Experience performing Worst-Case Performance and Stress Analysis including end-of-life effects.
Experience with test equipment such as oscilloscopes, spectrum analyzers, logic analyzers, and protocol analyzers.
Self-motivated individual with the ability to work and communicate effectively within a development group.
Ability to work in a team environment and negotiate solutions with Hardware, Software and Systems Engineering is preferred.
Proficiency with the Cadence toolset for CCA design (Schematic Capture, Constraint-Driven Layout, Simulation, Timing Analysis) is desired.
Monday, September 17, 2018
Tuesday, August 28, 2018
Know someone who would be a good fit? We pay for referrals!